KT200 ECU programmer is used to read and write Engine Control Units (ECU) FLASH and EEPROM in OBD, bench, and boot mode in heavy vehicles, passenger cars, motorcycles, marine and construction vehicles.

KT200 ECU Programmer is a complete tool for reading and programming engine control units via OBD and via the Boot mode and Jtag systems. Full system and Bench mode also available. 

GETOBDTOOL KT200 ECU Programmer Highlights:

  • KT200 ECU Programmer covering up to 5400 ECU, over 500 TCU.
  • Support Audi/VW ECU Clone via Bench Mode.
  • Support OBD/BENCH/BOOT/BDM/JTAG.
  • Software Version:22.08.205. 
  • Bosch EDC17, MED17/ME17, and SIEMENS Pcr2.1(with Pinout also nlocking possibility) read and write in Bench Mode.
  • Vehicle list is constantly updated stays ahead of the industry.
  • The KT200 ECU programmer software allows you to forcibly write (forcible clone) without checksumming and supports forcibly reading and writing unknown ECUs with supported chip models.
  • Covering a full range of German, ECU Programmer, Japanese, American and Chinese models.
  • Operation System: Windows 7, Windows 8/8.1, Windows 10, Windows 11, CPU > 2.5 GHz (Intel i5, i7), RAM > 8GB

 

How to Read Mitsubishi Outlander E6T70484 Engine Flash Data with KT200 ECU Programer?

  1. Download, Install and Active KT200 Software.

  2. Open KT200 Software.

  1. Seleted Driver

  1. Click "Tool Boot"

 Select Maker as "TOOLS BOOT MODE"

 Select Vehicle as "MTSUBISHI BOOT"

 Select Driver as "E6T70xxx Mtsubishi MH8102F"

Click "INFO"

It will come out a PDF as below

Plug cable as above picture.

Confirm the engine model number is E6T70484

Connect cable with KT200

Turn on this switch

Click " OK " 

Get ID

Commands DATA READING In Process

Once 100%, Click " Read File "

Save data

READING ECU in process, it will take several minutes.

END OF READ, TURN THE DASHBOARD OFF, Click "OK"

Job finished!